This EMax NIGHTHAWK 250 Pro mini quadcopter combo has virtually all of the components needed to build a light weight, agile and fast machine perfect for zipping around, FPV racing..............or whatever style you choose.
The extremely low-weight Mini Sport frame is pure carbon fibre designed to offer high-strength to weight ratio. This kit contains high-quality performance parts, making for an easy-build, fast and fun quad that is tons of fun to fly,
Features:
* Open Pilot CC3D flight controller
* Pure carbon fibre frame - no carbon/glass mix
* Futuristic design and styling
* Varied mounting holes offering several options for different bolt patterns
* Damping balls to prevent excess vibration to the flight controller
* Easy LiPo access
Specification:
* 250 Quadcopter frame
* Arm plate thickness: 4.75mm
* Main material: carbon fibre
* Diameter: 250mm (between motor centres)
* Weight: 190g
What's in the box:
* EMax Nighthawk 250 Pro all carbon frame (not carbon/glass mix)
* Open Pilot CC3D flight controller plus harness
* 4 x EMax MT2204 2300KV motors (2 x CW, 2 x CCW)
* 4 x EMax Simon series 12A ESCs
* 8 x M3 x 5mm standoffs
* 4 x M3 x 8mm screws
* 4 x M3 nuts
* 4 x Damping balls for flight controller
* 1 set of 6 x 3 carbon fibre props (2 x CW, 2 x CCW)
Required to complete:
* Radio system: TX/RX min 6-channel
* Flight battery: 1300~2200mAh 3S (11.1V) LiPo - to provide around 7 minutes flying time
* LiPo battery charger
Take it to the next level and install an FPV system for an immersive flight experience Click here and take a look at the Fatshark Attitudes.
IMPORTANT:
This flight controller is recommended for hobbyists with suitable technical knowledge. While the CC3D is incredibly capable, it requires a degree of skill to set up. BRC Hobbies cannot offer any technical support for this item. Please make use of the Open Pilot website or the various forums for support. A good starting point is here - click here
Note that returns on this item will not be accepted after soldering. BEFORE you start soldering or making any connections, please plug the board into your computer using an appropriate USB cable to check that the board works.
Note: Carbon fibre dust is toxic. Please wash your frame before assembly to remove any dust from the manufacturing process. You may also want to wet sand the edges so they are not sharp. Also please note that carbon fibre is electrically conductive so make sure that you do not have any exposed connections that could short against the carbon fibre frame. Carbon fibre will block RF signals so make sure that you place your receiver antennas so that they have sufficient clearance from the frame.
